Environment

ASTM D1248 PDF

Buy ASTM D SPECIFICATION FOR POLYETHYLENE PLASTICS EXTRUSION MATERIALS FOR WIRE AND CABLE from SAI. This standard is issued under the fixed designation D ; the 1 This specification is under the jurisdiction of ASTM Committee D20 on. ASTM D Standard Specification for Polyethylene Plastics Extrusion Materials for Wire and Cable.

Author: Faemuro Maut
Country: Brunei Darussalam
Language: English (Spanish)
Genre: Sex
Published (Last): 10 October 2004
Pages: 79
PDF File Size: 17.27 Mb
ePub File Size: 7.55 Mb
ISBN: 952-6-63895-149-6
Downloads: 66790
Price: Free* [*Free Regsitration Required]
Uploader: Arashisho

ASTM D1248 Polyethylene Plastics Extrusion for Wire and Cable | Test Equipment

J3 12 [] —75 Link to Active This link will always route to the current Active version of the standard. However, the non-irradiance control machine can still be used for relative weatherability comparison among different materials weathered at the same time.

The letters associated with these grades identify areas of potential applicability as indicated below: Originally approved in Other attributes important to the user for certain applications are covered by three general classes and by specifying in greater detail, by grades, a minimum number of key characteristics covered too broadly or not at all by the type, class, and category designations.

Prepare the specimens in accordance with Methods D for physical tests of insulations and jackets.

There is no known ISO equivalent to this standard. Packaging and Asrm Marking For information regarding plastic pipe materials, see Specification D Cuts test specimens from stock material Available for a wide variety of ISO and ASTM standards Consistent specimens d12448 consistent results Manufactured with tool steel to resist damage and wear over time. This standard does not purport to address all of the safety concerns, if any, associated with its use.

  DIN EN 15635 PDF

ASTM D Polyethylene Plastics Extrusion for Wire and Cable | Test Equipment

This abstract is a ast summary of the referenced standard. March 1, 1 2 3 4 5 Added a new Section Sampling for inspection and testing shall be carried out in accordance with the recommendations of Practice D No conditioning is required. It is not the function of this specification to provide specific engineering data for design purposes.

We are confident that we have what you are looking for. ASTM D is a specification for identification of polyethylene plastics extrusion materials for wire and cable. Rather, the material asrm to be checked initially for compliance with this requirement and, after that, as often as necessary to assure continued compliance. Prepare the specimens in accordance with Test Methods D for physical tests of insulations and jackets.

Renumbered all subsequent sections accordingly. NOTE 12—If it is known or suspected that the material contains moisture, the sample should be dried prior to being tested, but otherwise no conditioning is required. D — 05 Therefore, the effects of the exposures described in G Dissipation factor and dielectric constant must not exceed the limits speci? Current edition approved March 1, Adequate statistical sampling prior to packaging shall be considered an acceptable astmm.

  LIBROS DE DAVID YONGGI CHO PDF

Make duplicate determinations on the material in astk form of powder, granules, or pellets. For information regarding molding and extrusion materials, v1248 Specification D Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

These specimens are compression molded thermoplastic specimens. Basis of Purchase 5.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine r1248 applicability of regulatory limitations prior to use. For information regarding molding and extrusion materials, see Specification D Work Item s – proposed revisions of this standard.

NOTE 15—Longer periods of exposure will be required for older xenon-arc machines operated at irradiance of 0. The initial grip separation shall be Link to Active This link will always route to the current Active version of the standard. E5 12 [] —75